Problem Starting up Simx HLA1516

[Expt626]

Hi,

I have MAK RTI v 3.1.2 installed but I can't seem to start SimX.
I get " AcronSimXESP_HLA.exe = Entry Point Not Found. ..... The procedure entry point could not be located in the dynamic link library librti1516.dll"
Can't figure out was wrong. Advice would be very much appreciated.
Thanks

CA

[dtudino]

Hi,

That error could be occurring because of the Visual Studio version of the RTI libraries. SimX required the Mak 3.1.2 for VS 7 (.net/2003). If you're using the mak for VS 8, this could be the issue.

Thanks,
david